Laser Cutting with annular intensity distribution
نویسندگان
چکیده
منابع مشابه
Experimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملComposite Cavity Fiber Laser with Asymmetric Output Intensity and Wavelength
The composite cavity fiber laser (CCFL) is relatively simple in its fabrication, as it is essentially three wavelength matched Bragg gratings in a section of doped fiber. By using internal feedback with unequal sub-cavity lengths, unidirectional CCFLs with significantly asymmetric output power from its two outputs can be achieved. Preliminary results also show that it is possible for the lasing...
متن کاملLaser with thresholdless intensity fluctuations
We have studied the quantum-noise properties of a small slow-inversion laser experimentally and theoretically. As a function of pump rate, the average output intensity shows a sharp threshold, but the intensity fluctuations do not. Under quite generic conditions the intensity fluctuations of a sufficiently small slowinversion laser show highly super-Poissonian statistics ~even two times above t...
متن کاملZero Width Glass Cutting with CO2 Laser
Laser cutting of glass in not a novel technique, excellent results have already been achieved by various research institutes. There are several patents concerned with controlled cutting of glass with zero width and other brittle materials in a straight line using CO2 laser beam. Laser beam glass cutting produces a high quality cut edge with minimal microcracking. This is achieved using a contro...
متن کاملLaser Cutting Theory
A laser can be used for cutting by exposing material to the intense heat energy developed by its beam. If that heat input to the material is greater than that material's ability to reflect, conduct, or disperse the added energy, it will cause a sudden rise in temperature of the material at that point. If the temperature rise is substantial enough, the input heat is capable of initialising a hol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2020
ISSN: 2212-8271
DOI: 10.1016/j.procir.2020.09.168