LASER CLADDING WITH COBALT-BASED HARDFACING ALLOYS
نویسندگان
چکیده
منابع مشابه
Laser cladding of copper base alloys onto Al Si7 Mg0.3
Certain copper alloys have proved to be suitable for laser cladding onto aluminium base. By using the blown powder technique with a 1.5 KW C02 laser, clads without cracks or porosity have been produced. The base material has the composition Al Si7 Mg0.3 and the clads are made from alloyed copper with varying contents of Ni, Fe, Si and Al. Aluminium dilution in the clad can be kept lower than 1 ...
متن کاملEffect of laser irradiation conditions on the laser welding strength of cobalt-chromium and gold alloys.
Using tensile tests, this study investigated differences in the welding strength of casts of cobalt-chromium and gold alloys resulting from changes in the voltage and pulse duration in order to clarify the optimum conditions of laser irradiation for achieving favorable welding strength. Laser irradiation was performed at voltages of 150 V and 170 V with pulse durations of 4, 8, and 12 ms. For c...
متن کاملEffect of Cobalt on Microstructure and Wear Resistance of Ni-Based Alloy Coating Fabricated by Laser Cladding
Ni-based alloy powders with different contents of cobalt (Co) have been deposited on a 42CrMo steel substrate surface using a fiber laser. The effects of Co content on the microstructure, composition, hardness, and wear properties of the claddings were studied by scanning electron microscopy (SEM), an electron probe microanalyzer (EPMA), X-ray diffraction (XRD), a hardness tester, and a wear te...
متن کاملProcedure for Conducting Breakaway Oxidation Tests with Zirconium-based Cladding Alloys
4. Sample Preparation and Characterization 7 4.1 Hydrogen-content determination for as-fabricated samples 7 4.2 Minimum sample lengths for oneand two-sided oxidation tests 7 4.3 End-cap mass and welding procedure for one-sided oxidation test samples 7 4.4 Length, outer diameter, and wall thickness measurements 7 4.5 Pre-test cleaning with chemical detergent or organic solvent and rinsing 8 4.6 ...
متن کاملLaser Cladding of Ultra-Thin Nickel-Based Superalloy Sheets
Laser cladding is a well-established process to apply coatings on metals. However, on substrates considerably thinner than 1 mm it is only rarely described in the literature. In this work 200 µm thin sheets of nickel-based superalloy 718 are coated with a powder of a cobalt-based alloy, Co-28Cr-9W-1.5Si, by laser cladding. The process window is very narrow, therefore, a precisely controlled Yb ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1991
ISSN: 1155-4339
DOI: 10.1051/jp4:1991714