LASER CLADDING OF HOT WORK TOOL STEEL (H13) WITH NANO TIC PARTICLES
نویسندگان
چکیده
منابع مشابه
Laser deposited TiC/H13 tool steel composite coatings and their erosion resistance
The present work studies the synthesis and performance of TiC/H13 tool steel composite coatings obtained by the laser deposition technique. he effect of laser beam-scanning speeds and the concentrations of TiC in injected powder on the morphologies and microstructures of deposited eads are investigated. The results show that the beam-scanning speeds affect the size and morphology of the beads. ...
متن کاملNickel-based Superalloy Layer Deposited on AISI H13 Hot Tool Steel Base Metal Using Explosion Cladding process
An experimental test was carried out to explosively clad solution annealed Inconel 718 superalloy on quench-tempered AISI H13 hot tool steel. A wavy with vortices interface geometry was obtained from this experiment. A gradual change in the wavelength along the direction of welding was observed which was due to a change in the impact angle, following the plate contacts. In this paper, the exper...
متن کاملLaser Grooving of Surface Cracks on Hot Work Tool Steel
Repair welding (RW) with wire cladding is a common procedure to extend the in-service life of heavily loaded tool parts for die and mould industries 1-5 . The main advantages of repair welding are short downtime and cost efficiency compared to production of new tool part. Repair welding in general lowers the tool cost in the final part and enables higher added value to the die casting and injec...
متن کاملMicrostructure Evolution of TiC Particles In Situ, Synthesized by Laser Cladding
In this paper, a TiC reinforcement metal matrix composite coating is produced using nickel and graphite mixing powder on the surface ofTi-6Al-4V alloy by laser radiation. The microstructure of the coatings is investigated by XRD, SEM and EDS. Results show that most of the TiC phase is granular, with a size of several micrometers, and a few of the TiC phases are petals or flakes. At the cross-se...
متن کاملEVALUATION OF THE MECHANICAL PROPERTIES OF NIOBIUM MODIFIED CAST AISI H 13 HOT WORK TOOL STEEL
Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Turkish Journal of Engineering
سال: 2019
ISSN: 2587-1366
DOI: 10.31127/tuje.419531