Lap Welding of Titanium Sheet and Mild Steel Sheet by Seam Welding
نویسندگان
چکیده
منابع مشابه
Laser Welding of Thin Sheet Magnesium Alloys
Magnesium and its alloys are active materials, and the oxide can easily form when they react with air and moisture (Czerwinski 2002). In addition, magnesium and its alloys are flammable and require strict safeguards during the manufacturing process. These disadvantages make the processing of magnesium alloys into finished products more challenging. These drawbacks cause defects such as cracks, ...
متن کاملFine Micro-welding of Thin Stainless Steel Sheet by High Speed Laser Scanning
Fraunhofer Institute for Laser Technology had developed the SHADOW welding technique, in which high speed joining with minimal distortion is possible using a pulsed Nd:YAG laser. The possibility of high speed, high quality welding had been also reported by use of a single-mode fiber laser. The combination of micro-beam and high speed laser scanning offers potential advantages for thin metal she...
متن کاملCold lap formation in Gas Metal Arc Welding of steel
........ ............................................................................... VII Appended Publications ................................................................... IX Table of
متن کاملNumerical simulation of laser beam welding of Ti6Al4V sheet
This paper was aimed to report the 3D finite element analysis simulation of laser welding process of Ti6Al4V 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. The butt-joint welds were made using CO2 laser with the maximum power of 2.2 kW in the continuous wave mode. A part of the experimental work was carried out to verify the weld geome...
متن کاملnumerical simulation of laser beam welding of ti6al4v sheet
this paper was aimed to report the 3d finite element analysis simulation of laser welding process of ti6al4v 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. the butt-joint welds were made using co2 laser with the maximum power of 2.2 kw in the continuous wave mode. a part of the experimental work was carried out to verify the weld geome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 2003
ISSN: 0288-4771
DOI: 10.2207/qjjws.21.553