Laminate structures in plastic composite materials with rigid layers
نویسندگان
چکیده
منابع مشابه
Failure Criteria Analysis of Laminate Composite Materials
This paper deals with the development of a numerical simulation methodology for estimating damages in laminate composite materials caused by a low-speed impact. Experimental tests were performed on laminate plates reinforced with woven carbon fibers and epoxy resin. Three thickness plates were evaluated. The impact loads were transversal and punctual. Two lamina failure criteria were evaluated....
متن کاملLight propagation in composite materials with gain layers
Light propagation through a single gain layer and a multilayer system with gain layers is studied. Results obtained using the Fresnel formulas, Airy's series summation, and the numerical solution of the nonlinear Maxwell±Bloch equations by the finite difference time domain (FDTD) method are analyzed and compared. Normal and oblique propagation of a wave through a gain layer and a slab of a phot...
متن کاملMachining of Fibre Reinforced Plastic Composite Materials
Fibre reinforced plastic composite materials are difficult to machine because of the anisotropy and inhomogeneity characterizing their microstructure and the abrasiveness of their reinforcement components. During machining, very rapid cutting tool wear development is experienced, and surface integrity damage is often produced in the machined parts. An accurate selection of the proper tool and m...
متن کاملPlane Strain Slip Line Theory for Anisotropic Rigid/plastic Materials
A SLIP line theory governing states of incipient plane flow at the yield point load is developed for anisotropic rigid/plastic materials which exhibit a reduced yield criterion, governing states of plane flow, that depends only on the deviatoric parts of the in-plane stress tensor. It is shown that every homogeneous, incompressible material which complies with the principle of maximum plastic w...
متن کاملMachinability of glass fiber reinforced plastic (GFRP) composite materials
This paper deals with the study of machinability of GFRP composite tubes of different fiber orientation angle vary from 30 to 90. Machining studies were carried out on an all geared lathe using three different cutting tools: namely Carbide (K-20), Cubic Boron Nitride (CBN) and Poly-Crystalline Diamond (PCD). Experiments were conducted based on the established Taguchi’s Design of Experiments (DO...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2015
ISSN: 1617-7061
DOI: 10.1002/pamm.201510260