منابع مشابه
Mars: Wind Friction Speeds for Particle Movement
Wind friction threshold speeds (V,t) for particle movement were determined in a low pressure boundary layer wind tunnel at an atmospheric pressure of 5.3 mb. The results imply that for comparable pressures on Mars, the minimum V,t is about 2.5 m/sec, which would require free-stream winds of 50 to 135 m/sec, depending on the character of the surface and the atmospheric conditions. The correspond...
متن کاملEffect of Fluid Friction on Interstitial Fluid Flow Coupled with Blood Flow through Solid Tumor Microvascular Network
A solid tumor is investigated as porous media for fluid flow simulation. Most of the studies use Darcy model for porous media. In Darcy model, the fluid friction is neglected and a few simplified assumptions are implemented. In this study, the effect of these assumptions is studied by considering Brinkman model. A multiscale mathematical method which calculates fluid flow to a solid tumor is us...
متن کاملIntelligent Flow Friction Estimation
Nowadays, the Colebrook equation is used as a mostly accepted relation for the calculation of fluid flow friction factor. However, the Colebrook equation is implicit with respect to the friction factor (λ). In the present study, a noniterative approach using Artificial Neural Network (ANN) was developed to calculate the friction factor. To configure the ANN model, the input parameters of the Re...
متن کاملCFD-Calculation of Fluid Flow in a
An accurate description of the fluid flow and heat transfer within a Pressurized Water Reactor (PWR), for the safety analysis and reactor performance is always desirable. In this paper a mathematical model of the fundamental physical phenomena which are associated to a typical PWR is presented. The mathematical model governs the fluid dynamics in the reactor. Using commercial software CFX, a co...
متن کاملInvestigation of Injection-induced Seismicity Using a Coupled Fluid Flow and Rate/state Friction Model
This paper describes a numerical investigation of seismicity induced during injection into a single, isolated fracture. A model was developed and used that couples (1) fluid flow and (2) rate and state friction. Rate and state friction theory describes how friction on a fault depends on both sliding velocity and past sliding history. Rate and state friction is used widely in earthquake modeling...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Today
سال: 2006
ISSN: 1369-7021
DOI: 10.1016/s1369-7021(05)71325-0