Laboratory stiffness and flexibility tests of spiral corrugated high density polyethylene pipes of large diameters with metal reinforcement
نویسندگان
چکیده
منابع مشابه
Quality Monitoring at Fusion Welding of Polyethylene High-density Pipes
D. Šoštarić, A. Pintarić, Faculty of Electrical Engineering, J. J. Strossmayer University of Osijek, Osijek, Croatia. I. Samardžić, Mechanical Engineering Faculty, J. J. Strossmayer University of Osijek, Slavonski Brod, Croatia. The paper presents the main parameters of fusion welding and their Off line analysis of Polyethylene high-density (PE-HD) pipes. By direct measurements of voltage and c...
متن کاملthe washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولImmobilization of Rhizomucor miehei Lipase on High Density Polyethylene
Immobilization of Lipase produced from Rhizomucor miehei on HDPE fine powder was investigated. As compared to an aqueous system, immobilization in a non-aquous organic medium such as n-hexane was not successful and caused enzyme denaturation. Prewetting the support with ethanol increased the immobilized protein and enzyme activity as much as 31% and 34%, respectively. The maximum immobilized a...
متن کاملThe effect of high-energy electron beam on drawn and undrawn high density polyethylene fibers
HDPE monofilaments were obtained using different extruders and drawn by post-extruder equipments. After solidification, drawn and undrawn monofilaments (draw ratio 7:1) were irradiated with 10 MeV electron beams in air at room temperature at 25, 50, 75, 100 and 125 kGy dose ranges to induce a network structure. HDPE crosslinking was studied on the basis of gel content measurements. The fibers w...
متن کاملMorphology of Extruded High-Density Polyethylene Pipes Studied by Atomic Force Microscopy
Atomic force microscopy (AFM) was used to study the structure of extruded polyethylene (PE) pipe. During extrusion, the outer surface of the pipe was cooled with water. Two cross sections, parallel and transverse to the extrusion direction, were examined in order to spatially follow the structural development during extrusion. The morphology revealed was spherulitic, and the spherulites had a m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IMK-14 - Istrazivanje i razvoj
سال: 2015
ISSN: 0354-6829
DOI: 10.5937/imk1502047m