Kinetics pathway of precipitation in model Co-Al-W superalloy
نویسندگان
چکیده
منابع مشابه
Investigation of the Effect of Homogenization Treatment on Distribution of Alloying Elements, Microstructure and Hardness of Co-Al-W-Ti-Ta-Base Superalloy
The aim of this study was to investigate the effect of temperature and time of homogenization treatment on the microstructure, distribution of alloying elements and hardness of the novel Co-based superalloy Co-7Al-7W-4Ti-2Ta. For this purpose, the specimens were first homogenized at 1250 and 1300 °C for 2, 4, 6 and 8 hours and then water-cooled. Subsequently, the specimens were subjected to har...
متن کاملPrecipitation kinetics in N18 P/M superalloy : experimental study and numerical modelling
Heat treatments of aeronautical turbine disks produced by powder metallurgy include y' solutionning, quenching and subsequent annealing. In the present work, the intragranular y' precipitation kinetics during the quench has been followed by dilatometry and transmission electron microscopy. The precipitation steps are studied on specimens "hyperquenched" from selected temperatures during a simul...
متن کاملPREPARATION AND SINTERING OF W-20%Wt Cu COMPOSITE POWDERS PRODUCED BY CO-PRECIPITATION METHOD
Abstract: materials can be fabricated by sintering of W-Cu composite powders. In this research W-20%wt Cu composite powderswas synthesized via a co-precipitation method. Precipitate obtained from a mixture of copper nitrate and ammoniumparatungstate (APT) in distilled water contained W-Cu compounds. This precipitate was washed, dried and calcinedat 550 of dried precipitate powder was determined...
متن کاملA Model for Precipitation Kinetics and Strengthening in Al-Cu-Mg Alloys
A physically-based numerical model is developed to predict the microstructural evolution and strengthening in Al-Cu-Mg alloys during isothermal treatments. The modelling of the formation kinetics of the precipitates is based on the Kampmann and Wagner model. The strengthening by the shearable Cu:Mg co-clusters is modelled on the basis of modulus strengthening mechanism and the strengthening by ...
متن کاملCreep of Ni-Al and Ni-Cr-Al Superalloy Foams
The steady-state creep rate of Ni-base metallic foams, with superalloy composition (in wt. pct) Ni7.8∼9.1Al (relative density, ρ = 2.5-2.6) and Ni-13.5∼16.6Cr-5.1∼8.9Al (ρ = 2.8∼3.0), was measured under a range of temperatures (680∼825°C) and applied stresses (0.1∼0.3 MPa), and compared with that of NiAl intermetallic foams (ρ = 5.3). The stress exponent and activation energy are within the exp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2018
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2017.12.032