KD-S SiCf/SiC composites with BN interface fabricated by polymer infiltration and pyrolysis process
نویسندگان
چکیده
منابع مشابه
B4C-Al Composites Fabricated by the Powder Metallurgy Process
Due to the large thermal neutron absorption cross section of 10B, B4C-Al composites have been used as neutron absorbing materials in nuclear industries, which can offer not only good neutron shielding performance but also excellent mechanical properties. The distribution of B4C particles affects the mechanical performance and efficiency of the thermal neutron absorption of the composite materia...
متن کاملEnhancing the mechanical properties of BN nanosheet-polymer composites by uniaxial drawing.
We have used liquid exfoliation of hexagonal Boron-Nitride (BN) to prepare composites of BN nanosheets of three different sizes in polyvinylchloride matrices. These composites show low levels of reinforcement, consistent with poor alignment of the nanosheets as-described by a modified version of Halpin-Tsai theory. However, drawing of the composites to 300% strain results in a considerable incr...
متن کاملMachinable α-SiAlON/BN Composites
Dense machinable α-SiAlON/BN composites were fabricated by hot-pressing using turbostratic boron nitride (tBN) obtained from nitridation of melamine diborate. The tBN was added to the starting powders, or introduced as a coating that formed in situ on α-Si3N4 carrier powders during nitridation, and was subsequently converted to hexagonal boron nitride (hBN) during hot pressing by solution repre...
متن کاملExperimental Study on Sintering and Infiltration Process of Metal Part Fabricated by Mold Decomposed Injection Sculpturing
Mold Decomposed injection sculpturing (Mold DIS) process which integrates injection and sculpturing in layered manufacture is a novel rapid prototyping technique. In this paper a wax mold is fabricated through DIS process, the 316L stainless steel slurry is then cast into the mold. After curing and drying, the wax mold is melted and the green part is obtained. The purpose of this paper is to st...
متن کاملDeposition and characterization of SnO2:Sb thin films fabricated by the spray pyrolysis method
In this study, thin films of transparent semiconductor tin oxide doped with antimony impurities on the glass substrates with different concentrations of antimony that have been prepared using spray pyrolysis method. The effects of different concentration of antimony on the structural, optical, and electrical properties of the thin films were investigated. Prepared layers were characterized by X...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Ceramics
سال: 2018
ISSN: 2226-4108,2227-8508
DOI: 10.1007/s40145-018-0268-2