Kajian Numerik Efektifitas Film Cooling pada Sudu Turbin Gas
نویسندگان
چکیده
منابع مشابه
Efektifitas Teknologi Informasi Dalam Proses Belajar Mengajar Pada Universitas Budi Luhur
In general, however, IT will empower students to have greater control over the learning process, with all the benefits associated with active learning and personal responsibility. Not only will students decide when to learn and how to learn, increasingly they will also decide what to learn and how that learning is to be certified. Traditionally, higher education institutions have combined sever...
متن کاملSimulation of Mist Film Cooling on Rotating Gas Turbine Blades
Film cooling technique has been successfully applied to gas turbine blades to prevent it from the hot flue gas. However, a continuous demand of increasing the turbine inlet temperature to raise the efficiency of the turbine requires continuous improvement in film cooling effectiveness. The concept of injecting mist (tiny water droplets) into the cooling fluid has been proven under laboratory co...
متن کاملSimulation of Mist Film Cooling at Gas Turbine Operating Conditions
Air film cooling has been successfully used to cool gas turbine hot sections for the last half century. A promising technology is proposed to enhance air film cooling with water mist injection. Numerical simulations have shown that injecting a small amount of water droplets into the cooling air improves film-cooling performance significantly. However, previous studies were conducted at conditio...
متن کاملAn Innovation in Film Cooling of the Gas Turbine Blades Applying an Upstream Jet
A new design concept is introduced to control the near-wall integration between the hot-gas boundary layer and the cooling jets in order to enhance the adiabatic film cooling effectiveness of the gas turbine blades. In this new approach, another film cooling port, having a very low blowing ratio, which prevents formation of the counter-rotating vortex pare, is applied just upstream of the main ...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ROTASI
سال: 2019
ISSN: 2406-9620,1411-027X
DOI: 10.14710/rotasi.21.1.10-15