Joining of hybrid AA6063-6SiC p -3Gr p composite and AISI 1030 steel by friction welding
نویسندگان
چکیده
منابع مشابه
Dissimilar Welding of EN 10025 Carbon Steel to AISI 316L Stainless Steel by Friction Stir Welding
In the present Study, a dissimilar joint of carbon steel sheet EN 10025 with 316 L has been welded by FSW and the welding parameters were optimized by RSM software method. For investigation of mechanical properties and microstructural analysis carried out by using optical, scanning electron microscopes with EDS analysis, tensile and hardness test of different area of joints, SZ, TMAZ, HAZ, thei...
متن کاملDissimilar Welding of EN 10025 Carbon Steel to AISI 316L Stainless Steel by Friction Stir Welding
In the present Study, a dissimilar joint of carbon steel sheet EN 10025 with 316 L has been welded by FSW and the welding parameters were optimized by RSM software method. For investigation of mechanical properties and microstructural analysis carried out by using optical, scanning electron microscopes with EDS analysis, tensile and hardness test of different area of joints, SZ, TMAZ, HAZ, thei...
متن کاملFeasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملJoining of Al 6061 alloy to AISI 1018 steel by combined effects of fusion and solid state welding
The joining of a 6-mm thickness Al 6061 to AISI 1018 steel has been performed by the combined effects of fusion and solid state welding. The process is derived from friction stir welding (FSW) but with an adjustable offset of the probe location with respect to the butt line. Metallographic studies by optical microscopy, electron probe microscopy, and the utilization of the X-ray diffraction tec...
متن کاملfeasibility study on aluminum alloys and a441 aisi steel joints by friction stir welding
in this paper, welding feasibility between aa1100, aa5050 and aa6082 aluminum alloys and a441 aisi steel by friction stir welding has been studied. mathematical analysis of the heat generation during process showed that the maximum temperature produced in aa6082 aluminum alloy and a441 aisi joint but heat distribution in aa1100 aluminum alloy was higher than the other alloys. the investigation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Defence Technology
سال: 2017
ISSN: 2214-9147
DOI: 10.1016/j.dt.2017.05.014