Joining Car Body Steel Sheets Using the Clinching Method
نویسندگان
چکیده
منابع مشابه
Experimental Investigation on the Joining of Aluminum Alloy Sheets Using Improved Clinching Process
Aluminum alloy sheets have been widely used to build the thin-walled structures by mechanical clinching technology in recent years. However, there is an exterior protrusion located on the lower sheet and a pit on the upper sheet, which may restrict the application of the clinching technology in visible areas. In the present study, an improved clinched joint used to join aluminum alloy sheets wa...
متن کاملMechanical Evaluation of Joining Methodologies in Multi Material Car Body
The economical use of energy and other limited resources and the protection of the environment will be one of the main influencing cornerstones of tomorrow's mobility. Intensive efforts in the automotive industry focus on further reduction of CO2 emissions and higher energy efficiency in all phases of vehicle life cycles. Consequent development of lightweight design plays a major role for furth...
متن کاملbuckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Finite element simulation of the clinching process of steel sheets and study on influence of anisotropy on the mechanical behavior of joint
This article describes a numerical study on the TOX-clinching process of the steel sheets. In addition, the influence of plastic anisotropy of the material on joining parameters is analyzed by evolution of the joint parameters such as undercut and neck thickness and punch force-displacement curve. Finite element analysis with ABAQUS/CAE-Explicit program is used to simulate two dimensional and t...
متن کاملSTUDY OF JOINING MECHANISM (S) IN BRASS/STEEL/BRASS SANDWICH MATERIALS PREPARED BY SCRATCH BRUSHING METHOD
In this research, the mechanism of joining three sheets of metals, i.e. brass-steel-brass, by cold roll welding process has been studied. For this purpose, the two surfaces of steel sheets were roughened with stainless steel wire brush by different amounts, then the brass sheets were put on both sides of the steel sheets, before they were subjected to cold roll process. During rolling, peaks of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Mechanica Slovaca
سال: 2011
ISSN: 1335-2393,1339-3073
DOI: 10.21496/ams.2011.004