JFET monolithic preamplifier with outstanding noise behaviour and radiation hardness characteristics
نویسندگان
چکیده
منابع مشابه
Audiofrequency Measurement of Jfet Noise Vs . Temperature in a High Impedance Preamplifier
We describe a high impedance audiofrequency preamplifier and present au-diofrequency noise spectra for 2N4416 and U311 JF'ET's, in a temperature range from room temperature to 80O.K. It is found that optimum noise performance is obtained at-140'K. We present an analysis of some of the sources of noise. Amplifier input capacitance is a.lso measured and discussed.
متن کاملRadiation hardness studies on Monolithic Active Pixel Sensors
CMOS Monolithic Active Pixel Sensors (MAPS) form a promising sensor technology for the micro vertex detector (MVD) of the Compressed Baryonic Matter (CBM) experiment. The technology allows for building very thin (∼ 50 μm) detectors with a spatial resolution of few μm and a satisfactory time resolution of 10 μs. It is expected that within one run of CBM, the MVD will be exposed to a radiation do...
متن کاملVariation of Preamplifier Noise Figure With B0 Field Strength
Introduction High-field arrays with large numbers of coils require preamplifiers located close to the coils to minimize SNR losses incurred in cables. The design of low-noise preamplifiers for high-field MRI must thus ensure there is no performance degradation due to the presence or orientation of high magnetic fields. Preamplifier scattering (S) parameters have been known to vary with B0 field...
متن کاملAutomated Preamplifier Noise Parameter Measurement System Using a Combination Analyzer
Introduction Array coils for MRI use highly reflective, low-noise preamplifiers to boost signal levels while minimizing, respectively, inductive coupling [1] and added noise. The noise factor [2], i.e., the loss of SNR due to noise added by the preamp (or noise figure, NF, when expressed in dB) depends on the admittance seen by the preamplifier's input, Ys = Gs + iBs, according to the expressio...
متن کاملEvaluation of capacitance-voltage characteristics for high voltage SiC-JFET
Capacitance between terminals of a power semiconductor device substantially affects on its switching operation. This paper presents a capacitance–voltage (C–V) characterization system for measuring high voltage SiC–JFET and the results. The C–V characterization system enables one to impose high drain-source voltage to the device and extracts the capacitance between two of three terminals in FET...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 1993
ISSN: 0018-9499,1558-1578
DOI: 10.1109/23.256654