Isothermal extrusion using a uniform temperature billet
نویسندگان
چکیده
منابع مشابه
Modeling the Formation of Transverse Weld during Billet-on-Billet Extrusion
A comprehensive mathematical model of the hot extrusion process for aluminum alloys has been developed and validated. The plasticity module was developed using a commercial finite element package, DEFORM-2D, a transient Lagrangian model which couples the thermal and deformation phenomena. Validation of the model against industrial data indicated that it gave excellent predictions of the pressur...
متن کاملAn Estimation of a Billet Temperature during Reheating Furnace Operation
Reheating furnace is an essential facility of a rod mill plant where a billet is heated to the required rolling temperature so that it can be milled to produce wire. Although it is very important to obtain information on billet temperatures, it is not feasible during furnace operation. Consequently, a billet temperature profile should be estimated. Moreover, this estimation should be done withi...
متن کاملFEA analysis during extrusion of polygonal sections from round billet through linearly converging dies using SERR Technique
The extrusion of section from round billet poses a great challenge for theoretical modeling of the process using upper bound method. The greatest difficulty in three-dimensional upper bound method is to determine kinematically admissible velocity field. The SERR (Spatial Elementary Rigid Region) technique is fairly applicable for analyzing extrusion of sections having re-entrant corners. A modi...
متن کاملPrediction of Extrusion Pressure in Vortex Extrusion Using a Streamline Approach
Vortex extrusion (VE) is a severe plastic deformation technique which is based on the synergies between high strain accumulation and high hydrostatic pressure. Such a high amount of pressure, places a mandate to seek the method for investigation of the load under processing conditions. For this, kinematically admissible velocity field and upper bound terms based on Bezier formulation are develo...
متن کاملModeling and simulation of forward Al extrusion process using FEM
The main objective of this paper is to study the effect of extrusion parameters (extrusion stresses and temperature) and die geometry, i.e. extrusion radius, on the extruded aluminum quality using FEM Simulation Technique. For this purpose, the general FEA Software ABAQUS was used to set up the finite element model of the warm aluminum extrusion in two dimensions (2D). Aluminum alloy Al-2014 wa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2004
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.54.105