Iodination of Magnetron Sputtered Cu3N Films.
نویسندگان
چکیده
منابع مشابه
Structure and morphology of magnetron sputtered CoCr thin films
The growth characteristics of magnetron sputtered Co-22%Cr thin films on amorphous glass or carbon substrates have been investigated utilizing transmission electron microscopy, X-ray diffraction and electrical resistivity measurements. Results indicate that the initial deposit is “amorphous”. but that small crystallites form before the film reaches 5 nm film thickness. By 10 nm, well oriented g...
متن کاملVenting temperature determines surface chemistry of magnetron sputtered TiN films
Surface properties of refractory ceramic transition metal nitride thin films grown by magnetron sputtering are essential for resistance towards oxidation necessary in all modern applications. Here, typically neglected factors including exposure to residual process gases following the growth and the venting temperature Tv, each affecting the surface chemistry, are addressed for the first time. I...
متن کاملFabrication and Characteristics of RF Magnetron Sputtered ITO Thin Films
Indium tin oxide (ITO) films have been deposited onto glass substrates by ifmagnetron sputtering without insitu substrate heating. The as-deposited films have an electrical resistivity of 5x1O a-cm, visible transmittance of about 85%, and infrared (IR) reflectance of above 80% at 5 jim. The effect of sputtering parameters on the deposition rate and the electrical and optical properties of ITO f...
متن کاملAnnealing studies of magnetron-sputtered CoCr thin films
The microstructure and magnetic properties of annealed CoCr thin films of various thicknesses, deposited on glass substrates, were examined. In general, little grain growth upon annealing was observed. Low-angle grain boundaries, present in as-sputtered films of thickness ~50nm, were absent in annealed films. This occurs simultaneously with a decrease in the measured electrical resistivity. A r...
متن کاملCharacterization of bias magnetron sputtered tantalum oxide films for capacitors
Tantalum oxide films have been deposited by sputtering of tantalum target in an oxygen partial pressure of 2x10 mbar under various substrate bias voltages in the range from 0 to -150 V on glass and silicon substrates held at room temperature. The influence of substrate bias voltage on the chemical binding configuration, crystallographic structure, electrical and dielectric properties has been s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SHINKU
سال: 1992
ISSN: 0559-8516,1880-9413
DOI: 10.3131/jvsj.35.248