Investigations on Tungsten Inert Gas Welded Magnesium Alloy
نویسندگان
چکیده
منابع مشابه
Hot cracking in tungsten inert gas welding of magnesium alloy AZ91D
Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...
متن کاملOptimization of Weld Bead Width in Tungsten Inert Gas Welding of Austenitic Stainless Steel Alloy
This paper investigates the effects of process parameters on weld bead width of austenitic stainless steel SS-310 in tungsten inert gas welding. The four parameters namely welding current, type of gas, gas flow rate and included angle of weld plates during butt joint were varied at three levels. The DOE approach was used to design experimental conditions. Orthogonal array L9 was used for carryi...
متن کاملApplication Of Artificial Neural Network In Predicting The Weld Quality Of A Tungsten Inert Gas Welded Mild Steel Pipe Joint
The weld quality of Tunston inert gas welded joint has been investigated to identify the most economical weld parameters that will bring about optimum properties. Artificial neural network, has been used in the prediction and optimization of the Tunston inert gas weld of mild steel pipes. Neural network model was generated using the Levenberg-Marquardt algorithm with feed ward back propagation ...
متن کاملCorrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملThe principle Of Tungsten Inert Gas (TIG) Welding Process
Process This chapter presents the principle of tungsten inert gas (TIG) welding process besides important components of TIG welding system and their role. This process is also known as gas tungsten arc welding (GTAW) process. Further, fundamentals of heat generation, arc stability and arc efficiency have also been described. Additionally, comparison of argon and helium as shielded gases has bee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2018
ISSN: 1757-899X
DOI: 10.1088/1757-899x/416/1/012030