Investigations on clamping effects with Die-Less-Hydroforming-Structures
نویسندگان
چکیده
منابع مشابه
Numerical Study on Effect of Bilinear Pressure Path on Corner Filling in Hydroforming of Tube in Box-Shape Die
Die corner filling is very important in tube hydroforming process. Definition of the internal pressure path is a key factor in improving the corner filling. However, the factors that cause improvement of corner filling are still unclear. In this paper, effect of bilinear pressure path on corner filling in hydroforming of tube in box-shape die is studied using both finite element simulation and...
متن کاملAn Optimization of the New Die Design of Sheet Hydroforming by Taguchi Method
During the last few years, several sheet hydroforming processes have been introduced. Despite the advantages of these methods, they have some limitations. Of the processes, the two main ones are the standard hydroforming and hydromechanical deep drawing. A new sheet hydroforming die set was proposed that has the advantages of both processes and eliminates their limitations. In this method, a po...
متن کاملNumerical Investigations on the Effect of Pulsating Pressure on Improvement of Formability in Hydroforming of Bent Tube by FEM
In this paper, hydroforming process of bent tubes in T-shaped die is studied for pulsating and linear pressure paths by the finite element method. Forming Limit Diagrams (FLDs) and thickness distribution curves are used to investigate the effect of pulsating pressure on hydroforming process. In addition, the obtained numerical results are compared with experimental results of hydroforming of st...
متن کاملEffects of Clamping on the Laser Forming Process
Although considerable effort has gone into characterizing the laser forming process in terms of process parameters and conditions, there has been little emphasis on the effects of the mechanical and thermal constraints introduced by the clamping method utilized for a desired application. This research suggests means for investigating and predicting the resulting geometry of a specimen due to la...
متن کاملInvestigations on the Linearity of Indirect Effects with Different Methods
The tests were carried out on a carbonfibre reinforced structure with a number of wires with different kind of installation. The peak value of the current impulses ranges from 20 kA up to 200 kA and the comparison shows, that a reasonable linearity exists for carbonfibre reinforced material and that the deviations are always on the save side. The verification of the linearity has been checked t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2015
ISSN: 1617-7061
DOI: 10.1002/pamm.201510098