منابع مشابه
A Telecentric vision system for broach verification
A common machine vision task is to verify that a product has been properly fabricated or assembled. In the following paper, a vision system is described for confirming that a type of gear has been processed properly. The main problem in this application is the relatively large depth of the gear which results in a more complex image than the desired silhouette of the part. The resulting image sh...
متن کاملCenterpoint Theorems for Wedges
The Centerpoint Theorem states that, for any set S of n points in R, there exists a point p in R such that every closed halfspace containing p contains at least dn/(d+ 1)e points of S. We consider generalizations of the Centerpoint Theorem in which halfspaces are replaced with wedges (cones) of angle α. In R, we give bounds that are tight for all values of α and give an O(n) time algorithm to f...
متن کاملFloodlight illumination of infinite wedges
The floodlight illumination problem asks whether there exists a one-to-one placement of n floodlights illuminating infinite wedges of angles α1, . . . , αn at n sites p1, . . . , pn in a plane such that a given infinite wedge W of angle θ located at point q is completely illuminated by the floodlights. We prove that this problem is NP-hard, closing an open problem from 2001 [6]. In fact, we sho...
متن کاملCollision of Two Liquid Wedges
1. INTRODUCTION Splashing following the collisions of liquids or granular materials is often observed in a variety of natural and engineering problems, such as plunging or breaking water waves, liquid droplets impacting on a free surface or a thin film of the same liquid, etc. Splashing leads to fluid fragmentation and the generation of drops and spray as well as fluid aeration. These phenomena...
متن کاملTribological investigations of the load, temperature, and time dependence of wear in sliding contact
An effort was made to study and characterize the evolution of transient tribological wear in the presence of sliding contact. Sliding contact is often characterized experimentally via the standard ASTM D4172 four-ball test, and these tests were conducted for varying times ranging from 10 seconds to 1 hour, as well as at varying temperatures and loads. A numerical model was developed to simulate...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2009
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2009/a/1213-2489/mt/9/1/67