Investigations into Deformation Characteristics during Open-Die Forging of SiCp Reinforced Aluminium Metal Matrix Composites
نویسندگان
چکیده
منابع مشابه
Aging behavior of nano-SiCp reinforced AZ61 magnesium matrix composites
Male, born in 1962, Ph.D, Professor. He obtained his Ph.D at Nanchang University. His research and teaching interests mainly focus on magnesium/aluminum alloys and investment casting process. He has published more than 200 papers by now. E-mail: [email protected] Received: 2011-01-25; Accepted: 2011-05-04 *Yan Hong *Yan Hong, Hu Xiaowu, Nie Qiao and Chen Lei (School of Mechanical-Electrical En...
متن کاملCasting of SiC Reinforced Metal Matrix Composites
Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...
متن کاملRoller Burnishing of Particle Reinforced Aluminium Matrix Composites
Energy and resource efficient systems often demand the use of light-weight materials with a specific combination of properties. However, these requirements usually cannot be achieved with homogeneous materials. Consequently, composites enabling tailored properties gain more and more importance. A special kind of these materials is aluminium matrix composites (AMCs), which offer elevated strengt...
متن کاملElectro Discharge Machining Characteristics of Mg/SiCP Metal matrix composites by Powder Metallurgy (P/M) Techniques
The objective of this work is to investigate the effects of current, pulse on time and pulse off time in Electro Discharge Machining performance on material removal rate and tool wear rate of Mg/SiCp metal matrix composites. In this work the Mg/SiCp metal matrix composite specimens were prepared by powder metallurgy route. ELEKTRA PLUS spark erosion machine was used for the purpose. Brass tool ...
متن کاملGrinding of Aluminium-Based Metal Matrix Composites Reinforced with Al2O3 or SiC Particles
This paper presents results obtained from the grinding of aluminium-based metal matrix composites reinforced with either aluminium oxide (Al2O3) or silicon carbide (SiC) particles using grinding wheels made of SiC in a vitrified matrix or diamond in a resin-bonded matrix. The study used grinding speeds of 1100–2200 m min , a grinding depth of 15 m for rough grinding and 0.1–1 m for fine grindin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Powder Technology
سال: 2013
ISSN: 2090-7710,2090-7737
DOI: 10.1155/2013/183713