Investigation on sheet flexible-die drawing process
نویسندگان
چکیده
منابع مشابه
On the Optimum Die Shape in Rod Drawing Process Considering Work-Hardening Effect of Material
The assessment of the influence of the work-hardening of material on the optimum die profile and drawing force in rod drawing process is the main objective of the present paper. The upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the rod drawing process through curved dies. Analytical results of drawin...
متن کاملOn the optimum die angle in rod drawing process considering strain-hardening effect of material
In this paper, rod drawing process of strain-hardening materials is investigated by analytical, numerical and experimental methods. The classic upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the drawing process. For a given process conditions and mechanical properties of the rod material, the power ter...
متن کاملNumerical and Experimental Investigation of Deep Drawing Process in Square Section of Single-Layer and Two-Layer Sheet
Deep drawing of two-layer sheet is a suitable way to achieve product with a desired shape and desired properties in sheet metal forming technology. Control of deep drawing parameter such as thinning is the most important challenge in this process. The most difficult part of this challenge is differences in material properties and geometry of each layer. In this paper, numerical approach has bee...
متن کاملNumerical and Experimental Investigation of the Effect of Open-Die Hot Deep Drawing Process Parameters on the Formability of Commercially Pure Titanium
In the present study, the finite element analysis of the hot deep drawing process of commercially pure (CP) titanium has been performed without the blank holder in order to investigate the influence of temperature (T), die radius (Rd) and blank diameter (D) on the maximum punch force (Fp) and minimum thickness of the blank (t). Tensile tests were first conducted to extract...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2021
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1798/1/012033