Investigation on dry machining of stainless steel 316 using textured tungsten carbide tools

Check Tic-coated Tungsten Carbide Tool Wear in Machining Steel

In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as...

Interface Deepening of Novel Tungsten Carbide- Stainless Steel Composites through Hr-tem

Investigation of Diamond Deposition on AISI 316 & 430 Stainless Steel Substrares

In this paper, the nucleation and growth of diamond/diamond-like coatings on austenitic (AISI 316) and ferritic (AISI 430) stainless steel substrates have been investigated using torch technique. The effects of substrate surface preparation has also been studied. The quality of coatings produced has been examined using optical and scanning electron microscopy, X-ray diffraction, Raman spectros...

Investigation of Diamond Deposition on AISI 316 & 430 Stainless Steel Substrares

In this paper, the nucleation and growth of diamond/diamond-like coatings on austenitic (AISI 316) and ferritic (AISI 430) stainless steel substrates have been investigated using torch technique. The effects of substrate surface preparation has also been studied. The quality of coatings produced has been examined using optical and scanning electron microscopy, X-ray diffraction, Raman spectros...

An Investigation on Mechanical Properties of Ultrafine Grained 316 Stainless Steel by Thermomechanical Treatment

In this paper, an advanced thermo-mechanical treatment was conducted on AISI 316 austenitic stainless steel. At first, three samples were rolled at the ambient temperature, the temperature of -20 ºC (dry ice and ethanol) and -196 ºC (liquid nitrogen). Then, the samples were annealed at 800 ºC in the time range of 1 to 15 minutes. In each step, the microhardness values of the samples were measur...