Investigation on Darrieus type straight blade vertical axis wind turbine with flexible blade
نویسندگان
چکیده
منابع مشابه
Dynamic Response of Flexible Wind Turbine Blade
Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...
متن کاملWind Turbine Blade Design
A detailed review of the current state-of-art for wind turbine blade design is presented, including theoretical maximum efficiency, propulsion, practical efficiency, HAWT blade design, and blade loads. The review provides a complete picture of wind turbine blade design and shows the dominance of modern turbines almost exclusive use of horizontal axis rotors. The aerodynamic design principles fo...
متن کاملEffect of rotor blade position on Vertical Axis Wind Turbine performance
In this paper a numerical study is presented with the aim of evaluating the performance output of three Vertical Axis Wind Turbine (VAWT) configurations. Here using Computational Fluid Dynamics (CFD) a two-dimensional Multi Reference Frame (MRF) approach has been used to perform steady state simulations. For this purpose an inlet velocity of 4m/s has been used along with rotor blade Tip Speed R...
متن کاملEffect of Blade Faults on the Performance Characteristics of a Vertical Axis Wind Turbine
Due to the diminishing reserves of fossil fuels and increased pollution from exploitation of these fuels, the world is focusing on the renewable energy sources. Wind is being considered as one of the prime next generation energy sources. Considerable amount of research is being carried out on the innovative designs for maximizing the performance of wind turbines. Furthermore, a lot of research ...
متن کاملThermo-chemical Simulation of a Composite Offshore Vertical Axis Wind Turbine Blade
In the present study three dimensional steady state thermo-chemical simulation of a pultrusion process is investigated by using the finite element/nodal control volume (FE/NCV) technique. Pultrusion simulation of a composite having a C-shaped cross section is performed as a validation case. The obtained cure degree profiles for specific points match well with those in the literature. Following ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Ocean Engineering
سال: 2015
ISSN: 0029-8018
DOI: 10.1016/j.oceaneng.2015.10.027