Investigation on Cutting Performance of Micro-Textured Cutting Tools
نویسندگان
چکیده
منابع مشابه
Investigation of Micro Square Structure Fabrication by Applying Textured Cutting Tool in WEDM
This paper studies micro structure fabrication by means of a textured tool cutting edge, which is manufactured by applying the wire cut electrical discharge machining (WEDM). Machining performance of the square structure fabrication on the tool cutting edge is investigated in the WEDM process, and the machining accuracy is explored in experimental analyses. In this proposed method, undesired ov...
متن کاملThe Effects of ZrO2 or Tic on the Performance of the Alumina-Based Ceramic Cutting Tools
Two types of alumina-based cutting tools with compositions of 90 vol.% Al2O3+10 vol.% ZrO2 and 80 vol.% A12O3+20 vol.% TiC are produced by isostatic pressing and sintering technique. The effects of these additives on the mechanical properties and cutting performance of these materials are investigated. The tool life in both materials is examined under identical conditions on cutting a grey cast...
متن کاملSurface Roughness Investigation of the Cutting Edge of the High Precision Cutting Tools Enabled by Micro and Nanometrological Measurements
The manufacturing technology of milling, drilling and turning tools have demands of new developing markets as well as quality and lifetime aspects of the machining. In order to achieve the high precision required by machining, the structure and form of the cutting edge of the tools must be investigated to provide the most influential properties. Correlation between the tool wear on the cutting ...
متن کاملImproved metal cutting performance with biasmodulated textured Ti0.50Al0.50N multilayers
In this work we present the cutting performance of Ti0.50Al0.50N coatings which have been deposited with both a fixed and an alternating bias of -35 V and -70 V together with a Ti0.33Al0.67N reference coating grown at -35 V. During deposition of the bias-layered coatings, the bias was instantaneously changed with four different bias-layer periods ranging from approximately 250 to 1500 nm. For t...
متن کاملResearch on Cutting Performance of Ceramic Cutting Tools in Milling High Density Fiberboard
The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Micromachines
سال: 2019
ISSN: 2072-666X
DOI: 10.3390/mi10060352