Investigation of Web Hole Effects on Capacities of Cold-Formed Steel Channel Members
نویسندگان
چکیده
Abstract Cold-formed steel structures have been widely applied in structural buildings with advantages manufacturing, transportation and assembly. Holes can be pre-punched the sectional members to allow technical pipes go throughout such as electricity, water or ventilation. This affects capacities of these which considered design standards America Australia/New Zealand. The paper, therefore, investigates effects web holes on cold-formed channel under compression bending. Their determined according American Specification AISI S100-16. investigated results are base for analysing hole dimensions behaviors members. It was found that capacity reductions were obtained compressive increase sizes, but flexural noticeable heights.
منابع مشابه
Local and Distortional Buckling of Cold-Formed Steel Members
Laminar structures have a high post-buckling strength reserve. Cold-formed steel profiles can be taken as a set of thin plate elements. Therefore it is necessary to design this type of profiles taking into account that reserve of strength in post-local buckling modes of failure. The method normally used to design this type of structures is based on the Effective Width concept. The Effective Wid...
متن کاملYield - line analysis of cold - formed steel members
The objective of this paper is to provide a state of the art review of the application of yield-line analysis to cold-formed steel members, and present a newly developed solution to the stresses that develop in an inclined yield-line. Yield-line analysis in cold-formed steel members is shown to be distinct from traditional yield-line applications. Challenges in the application of yield-line ana...
متن کاملExperimental Investigation on Cold-formed Steel Wall Plate System
A series of tests on cold-formed steel (CFS) wall plate system subjected to uplift force at the mid span of the wall plate is presented. The aim of the study was to study the behaviour and identify the modes of failure of CFS wall plate system. Two parameters were considered in these studies: 1) different dimension of U-bracket at the supports and 2) different sizes of lipped Cchannel. The lipp...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملReview on Cold-Formed Steel Connections
The concept of cold-formed light steel framing construction has been widespread after understanding its structural characteristics with massive research works over the years. Connection serves as one of the important elements for light steel framing in order to achieve its structural stability. Compared to hot-rolled steel sections, cold-formed steel connections perform dissimilarity due to the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Lecture notes in civil engineering
سال: 2023
ISSN: ['2366-2565', '2366-2557']
DOI: https://doi.org/10.1007/978-981-99-1748-8_13