INVESTIGATION OF SURFACE ROUGHNESS AND MICROHARDNESS IN BALL BURNISHING PROCESS OF AZ31B MAGNESIUM ALLOY
نویسندگان
چکیده
منابع مشابه
Analysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملExperimental Investigation of the Influence of Burnishing Parameters on Surface Roughness and Hardness of Brass Alloy
Nanoparticles of iron oxide (Fe3O4) were obtained by Coprecipitation with synthesis time of 30, 60 and 90 min. The morphology of the samples was investigated by scanning electron microscopy (SEM) and structural characteristics were obtained by X-ray diffraction (XRD). The crystallite size was calculated from the spectrum X-ray diffraction with the application of the Scherrer equation and Winfit...
متن کاملProcess Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy
The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and basal plane crystallographic texture, which significantly improve the corrosion resistance of magnesium alloy. These studies have focused on the positive effects of cryogenic coo...
متن کاملDetermination of Surface Roughness by Ball Burnishing Process Using Factorial Techniques
Burnishing is a method of finishing and hardening machined parts by plastic deformation of the surface. Experimental work based on central composite second order rotatable design has been carried out on a lathe machine to establish the effects of ball burnishing parameters on the surface roughness of brass material. Analysis of the results by the analysis of variance technique and the F-test sh...
متن کاملOptimizing the Process Parameters of Friction Stir Welded Joint of Magnesium Alloy Az31b
This paper deals with Friction stir welding of AZ31B Mg alloy by using H13 Tool at different rotational speeds and welding speeds .Experiments were conducted according to L4 Orthogonal array which was suggested by Taguchi. Optimum parameters for optimum Tensile strength, Hardness and Ductility were found with the help of S/N ratios. Therefore optimization of input process parameter is required ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Selcuk University Journal of Engineering ,Science and Technology
سال: 2018
ISSN: 2147-9364
DOI: 10.15317/scitech.2018.122