Investigation of Flat Plate Solar Collector using Al2O3-water Nanofluid. (Dept M ( Power ))
نویسندگان
چکیده
منابع مشابه
The Exergy Optimization of a Flat-Plate Solar Collector Using AL2O3-Water, CuO-Water and TiO2-Water Nanofluids by Genetic Algorithm
In this study, the exergy efficiency of a flat plate solar collector using Al2O3, TiO2, CuO nanoparticles and pure water as base fluid is studied. Solar radiation is selected between 200 to 600 W/m2. The method to determine optimum values of optimization variables has been developed by Genetic Algorithm Toolbox in MATLAB software. Results show by increasing solar radiation the optimized exergy ...
متن کاملAn experimental investigation on the performance of a symmetric conical solar collector using SiO2/water nanofluid
One of the effective methods to improve the thermal efficiency of solar collectors is using nanofluids as the coolant. The present study experimentally investigated the effect of SiO2/water nanofluid with 1% mass fraction on the performance of a symmetric collector, i.e. conical solar collector. The conical solar collector with 1 m2 area and normal to the earth was tested in Ahvaz, a city in th...
متن کاملEnergy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector
For a solar thermal system, increasing the heat transfer area can increase the output temperature of the system. However, this approach leads to a bigger and bulkier collector. It will then increase the cost and energy needed to manufacture the solar collector. This study is carried out to estimate the potential to design a smaller solar collector that can produce the same desired output temper...
متن کاملExperimental investigation of the thermophysical properties of AL2O3-nanofluid and its effect on a flat plate solar collector.p
Available online 12 September 2013
متن کاملExperimental investigation on performance comparison of nanofluid-based direct absorption and flat plate solar collectors
In the present work, a prototype of a new type of solar collectors, which called Direct Absorption Solar Collector, was built and its thermal performance is experimentally compared with conventional flat plate solar collector under transient and steady state conditions. Different volume fractions of multi wall carbon nanotubes in water and ethylene glycol mixture (70%:30% in volume) were used a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Faculty of Engineering. Mansoura University
سال: 2020
ISSN: 1110-0141
DOI: 10.21608/bfemu.2020.103792