Investigation of Brake disc using Metal Matrix Composites
نویسندگان
چکیده
منابع مشابه
Basics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملInvestigation of the Coatings Applied onto Brake Discs on Disc-brake Pad Pair
In severe conditions, braking may cause the temperature on the disc-pad interface to rise up to 800 °C 1 . At such a temperature, the properties of organic compounds are disrupted, coefficient of friction (CoF) decreases, and the rate of wear increases exponentially. This phenomenon is called “fade” 2 . Ideal brake pads, without causing any fades, are expected to function in uniform and stable ...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملTribocorrosion in Metal Matrix Composites
One of the biggest motivations behind the development of the metal matrix composites (MMCs) is the improvement of the mechanical wear resistance of the unreinforced metallic matrix material mainly by the load-bearing effect of the hard reinforcement phases. However, in a large number of applications, MMCs are also required to operate in intimate contact with aqueous environments, which may lead...
متن کاملInvestigation of Parameters Involved in the Production of Aluminum Matrix Composites Using Hot Powder Extrusion
Aluminum matrix composites reinforced with Al2O3 and SiC particles (5 Vol%) were produced using the hot powder extrusion method. Extrusion temperature and extrusion reduction in area were chosen in the range of 500 to 600°C and 90 to 95%, respectively. The physical and mechanical properties of the extruded composites such as density, tensile strength, elongation and microhardness were evaluated...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2020
ISSN: 1757-899X
DOI: 10.1088/1757-899x/988/1/012119