Inverse Parameter Identification for Orthotropic Elasto-Plastic Sheet-Steel
نویسندگان
چکیده
منابع مشابه
Parameter sensitivity of anisotropic elasto-plastic shell
1.Abstract A continuum-based design sensitivity analysis (DSA) applied to the thickness design of the anisotropic elasto-plastic shell structures is developed. Since main interest lies in developing path-following algorithms for solving sensitivity problems of elasto-plasticity, such an incremental or a step-by-step formalism will be employed to implementation into the structural analysis progr...
متن کاملOptimal control for elasto-orthotropic plate
Abstract: The optimal control problems and a weight minimization problem are considered for elastic three-layered plate with inner obstacle and friction condition on a part of the boundary. The state problem is represented by a variational inequality and the design variables influence both the coefficients and the set of admissible state functions. We prove the existence of a solution to the ab...
متن کاملA plane stress anisotropic plastic flow theory for orthotropic sheet metals
A phenomenological theory is presented for describing the anisotropic plastic flow of orthotropic polycrystalline aluminum sheet metals under plane stress. The theory uses a stress exponent, a rate-dependent effective flow strength function, and five anisotropic material functions to specify a flowpotential, an associated flow rule of plastic strain rates, a flow rule of plastic spin, and an ev...
متن کاملError estimates for elasto-plastic problems
— Under some reasonable smoothness assumpfions on the displacements, we are able to dérive an error estimate of the form ||a — <7h||L2{fl)^ Ch, for the approximation of the stress field a in some problems in elasto-plasticity. Using the same ideas, we als o find a piecewise line ar approximation of Mosolov's problem, for which we still get an 0 (h) error estimate.
متن کاملLoad partitioning between ferrite and cementite during elasto-plastic deformation of an ultrahigh-carbon steel
An ultrahigh-carbon steel was heat-treated to form an in situ composite consisting of a fine-grained ferritic matrix with 34 vol.% submicron spheroidized cementite particles. Volume-averaged lattice elastic strains for various crystallographic planes of the a-Fe and Fe3C phases were measured by synchrotron X-ray diffraction for a range of uniaxial tensile stresses up to 1 GPa. In the elastic ra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2015
ISSN: 1617-7061
DOI: 10.1002/pamm.201510171