Interstitial order and embrittlement in Ta-C alloys
نویسندگان
چکیده
منابع مشابه
First-principles calculation of phase equilibrium of V-Nb, V-Ta, and Nb-Ta alloys
In this paper, we report the calculated phase diagrams of V-Nb, V-Ta, and Nb-Ta alloys computed by combining the total energies of 40–50 configurations for each system (obtained using density functional theory) with the cluster expansion and Monte Carlo techniques. For V-Nb alloys, the phase diagram computed with conventional cluster expansion shows a miscibility gap with consolute temperature ...
متن کاملStudies of Radiation Embrittlement of Model Alloys by Thermoelectric Measurements and Positron Annihilation Spectroscopy
One of the basic mechanisms of radiation embrittlement of steels and welds is due to matrix damage. Embrittlement results in a raise in the ductile-to-brittle transition temperature, which is normally used as indicator of the degradation status of the material. Other methods different than mechanical tests can be used to follow embrittlement like small punch test, non-destructive measurements o...
متن کاملSp 3 content in ta - C
Tetrahedral amorphous carbon (ta-C) films were studied with and without applying fixed pulse bias and frequency at variable pulse widths in double bent Filtered Cathodic Vacuum Arc(FCVA) system. Both from Raman and X-ray photoelectron spectroscopy(XPS) analyses it has been observed that the ratio of sp/sp is maximal at pulse width of 15 μs with fixed pulse bias 3kV and frequency 200 kHz. Increa...
متن کاملEmbrittlement of Al-Li-Cu-Mg alloys at slightly elevated temperatures: microstructural mechanisms of hardening
When underaged, damage tolerant Al-Li based alloys are exposed to slightly elevated temperatures (60 to 100oC), their strength increases and toughness decreases. To study the first stages of this process, 8090 sheet in three underaged heat treatment conditions, including T3, T81 and a multistage temper, was exposed for 1000 h at 70°C. Using a model for strengthening in combination with a quanti...
متن کاملHydrogen Embrittlement of High Strength Steel Electroplated with Zinc-cobalt Alloys
Slow strain rate tests were performed on quenched and tempered AISI 4340 steel to measure the extent of hydrogen embrittlement caused by electroplating with zinc-cobalt alloys. The effects of bath composition and pH were studied and compared with results for electrodeposited cadmium and zinc-10%nickel. It was found that Zinc-1%cobalt alloy coatings caused serious hydrogen embrittlement (EI 0.63...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica
سال: 1975
ISSN: 0001-6160
DOI: 10.1016/0001-6160(75)90123-6