Internal Stress in Quenching of Solid Steel Cylinder
نویسندگان
چکیده
منابع مشابه
An Experimental Study of the Steel Cylinder Quenching in Water-based Nanofluids
In this study, some parameters such as quenching and boiling curves of a stainless steel cylindrical rod 80 mm long and having a diameter of 15 mm were experimentally obtained in saturate pure water and two nanofluids (SiO2 and TiO2) with 0.01 wt%. The cylinder was vertically lowered into the pool of saturated water and its temporal center temperature was measured by a the...
متن کاملQuenching stress, quenching current and plastic strain in superconductors
mechanical stress and maximum superconducting current have been calculated for a superconductor subjected to uniform plastic deformation. The training effect due to strain hardening o f the material is discussed. These results are compared with an analogous case when the normal transition is caused by the thermo-magnetomechanical instability. The quenching current is shown to depend on the hist...
متن کاملnon-linear study of various slit shear walls in steel structures
seismic retrofit strategies have been developed in the past few decades following the introduction of new seismic provisions and the availability of advanced materials and methods. it can be observed that new approaches to deal with more lateral forces are more innovative and more energy absorbent. in line with this, there is a growing trend toward the use of steel shear walls as a system with ...
15 صفحه اولSimulation And Control Of Tool Steel Quenching Process
Tool steels are widely used materials for making elements of metals, polymers, ceramics and composites. Inflated consumer expectations of contemporary civilization entail the manufacture of better and better tools, accompanied by reduced energy consumption. The application of simulators and controls of technological processes enables the design of optimum processes without the need for time con...
متن کاملInternal Stress Monitoring of In-Service Structural Steel Members with Ultrasonic Method
Internal stress in structural steel members is an important parameter for steel structures in their design, construction, and service stages. However, it is hard to measure via traditional approaches. Among the existing non-destructive testing (NDT) methods, the ultrasonic method has received the most research attention. Longitudinal critically refracted (Lcr) waves, which propagate parallel to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Applied Mechanics of Japan
سال: 1952
ISSN: 1883-549X
DOI: 10.2322/jjsass1948.5.64