Internal Strain Measurement Using Pulsed Neutron Diffraction at Lansce
نویسندگان
چکیده
منابع مشابه
New Pulsed Cold Neutron Beam Line for Fundamental Nuclear Physics at LANSCE
The NPDGamma collaboration has completed the construction of a pulsed cold neutron beam line on flight path12 at the Los Alamos Neutron Science Center (LANSCE). We describe the new beam line and characteristics of the beam. We report results of the moderator brightness and the guide performance measurements. FP12 has the highest pulsed cold neutron intensity for nuclear physics in the world.
متن کاملStudy on Measurement Technique for Lattice Spacing at Strain Free by Neutron Diffraction Method
For precise stress analysis of engineering materials by diffraction methods, the lattice spacing of strain-free materials, d0, must be accurately measured and determined. In this study, a new and easy technique of measuring the specimen is proposed which involves using the original material instead of its powder form for accurate estimation of d0 . The value of d0 obtained by our technique is e...
متن کاملInvestigation of Acrylic Acid at High Pressure Using Neutron Diffraction
This article shows that pressure can be a low-intensity route to the synthesis of polymethacrylic acid. The exploration of perdeuterated methacrylic acid at high pressure using neutron diffraction reveals that methacrylic acid exhibits two polymorphic phase transformations at relatively low pressures. The first is observed at 0.39 GPa, where both phases were observed simultaneously and confirm ...
متن کاملDepth capabilities of neutron and synchrotron diffraction strain measurement instruments. II. Practical implications
In part I [Withers (2004). J. Appl. Cryst. 37, 596±606], a framework was presented for estimating the maximum feasible penetration length for neutron and synchrotron X-ray strain measurement. This calculation re ̄ected the attenuation and scattering capability of the material under examination, the incident ̄ux and detector arrangement, the likely background signal, the required strain measuremen...
متن کاملPrinciples for Timing at Spallation Neutron Sources Based on Developments at Lansce
Due to AC-power-grid frequency fluctuations, the designers for accelerator-based spallation-neutron facilities have worked to optimize the conflicting demands of accelerator and neutron chopper performance. For the first time, we are able to quantitatively access the tradeoffs between these two constraints and design or upgrade a facility to optimize total system performance using powerful new ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MRS Proceedings
سال: 1994
ISSN: 0272-9172,1946-4274
DOI: 10.1557/proc-376-391