Interference in Internal Involute Spur Gears
نویسندگان
چکیده
منابع مشابه
Measuring Geometrical Parameters of Involute Spur Gears to Sub-pixel Resolution
The problem of accurate determination of the position, orientation and width of involute spur gear teeth using a single front-lit image is addressed. The information is used to compute global measures of tooth concentricity and pitch variations across a gear wheel. The approach is based on the use of specialised filters which make maximum use of the grey level information available in the image...
متن کاملSpatial involute gearing - a new type of skew gears
This is a geometric approach to spatial involute gearing which has recently been developed by Jack Phillips [4]. Due to Phillips' fundamental theorems helical involute gears for parallel axes (Fig. 2) serve also as tooth flanks for a uniform transmission between skew axes, and the transmission ratio is even independent of the relative position of the axes.
متن کاملImplementation of the Spur Involute Gear Model on Modelica
A procedure to build up a dynamical model of the gearbox with spur involute mesh is being described. The main attention is paid to the design technology of the cylindrical bodies elastic contact models. To track geometry of contact implicit equations of algebraic/transcendental or differential-algebraic type are being used. At the same time dynamical models of the bodies involved, gearwheels an...
متن کاملOptimal Selection of Addendum Modification Coefficients of Involute Cylindrical Gears
Based on the principles of equalized sliding coefficients and equalized teeth bending strength, the optimization mathematical model for calculating and allocating the addendum modification coefficients of involute cylindrical gear is firstly established. Then the measures to calculate the tooth parameters in real-time during the optimization steps are achieved. Finally, the optimization program...
متن کاملBending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1955
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.21.749