Interfacial Structure in Vertical Upward Annular Flow
نویسندگان
چکیده
منابع مشابه
Modeling of Upward Subcooled Flow Boiling of Refrigerant-113 in a Vertical Annulus
In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...
متن کاملNumerical investigation of upward air-water annular, slug and bubbly flow regimes
In this paper, numerical investigation of upward two phase flow of air-water has been studied. Different conditions of flow regimes including annular, wispy annular, slug, churn and bubbly are simulated based on Hewitt and Roberts map, and a good agreement between the experimental data of the map and the numerical simulation has been observed. Accordingly, a proper CFD model in CFD software of ...
متن کاملAn Experimental Investigation on Flow Characteristics of Refrigeration/Oil Mixture in Vertical Upward Flow
Oil return from the evaporator to the compressor suction port is an important requirement. It is affected by the refrigerant/lubricant properties, gas velocities and piping geometry. The refrigerant R -134a has successfully replaced R-12 in household refrigerators and freezers. This paper describes a test method to estimate the mean oil film thickness and to observe the flow pattern in vertical...
متن کاملthe effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
laminar flow in annular conduits
the flow of fluids in annular conduits has been studied for over sixty years, however the resulted data are very scattered. in this paper the problem is analytically solved, starting out with navier-stokes equations. a computer solution is used to determine the shape of velocity profiles, the discharge and the friction factor in a large number of concentric and eccentric annular conduits. the e...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF THE FLOW VISUALIZATION SOCIETY OF JAPAN
سال: 1985
ISSN: 1884-0361,0287-3605
DOI: 10.3154/jvs1981.5.supplement_61