Interfacial Layer in Friction-Bonded Joint of Low Carbon Steel to Al-Mg Alloy (AA5083) and its Influence on Bond Strength
نویسندگان
چکیده
منابع مشابه
Failure Investigation of Hydrogen Blistering on Low-strength Carbon Steel
The current study assesses the root causes of hydrogen blisters on low strength carbon steel equipment. For this purpose, some experiments including hardness test, non-destructive test (NDT), metallography, and fractograpghy are conducted. The microstructure of two blisters is assessed by means of optical microscopy and scanning electron microscopy (SEM). The microstructural studies show that t...
متن کاملROLE OF SURFACE TEXTURE ON FRICTION AND TRANSFER LAYER FORMATION WHEN Mg-8Al ALLOY SLID AGAINST STEEL COUNTERFACE
Surface texture influences friction and transfer layer formation during sliding. In the present investigation, various kinds of surface texture with varying roughness were produced on steel plates. Pins made of Mg-8Al alloy were then slid against the prepared steel plates using inclined pin-on-plate sliding tester to understand the role of surface texture of the harder surface and load on coeff...
متن کاملEvaluation of microstructure and mechanical properties of 410NiMo as an overlay layer on low alloy steel
The aim of this study is to reach an increased service life for parts using in sour environment by weld overlaying process. In this investigation, two successive layers of ER410NiMo were clad on low alloy steel substrates. To reduce the likelihood of Hydrogen Induced Cracking (HIC) and producing stable hydrogen traps, Post Weld Heat Treatment (PWHT) was conducted. Microstructural analysis, X-ra...
متن کاملEvaluation of microstructure and mechanical properties of 410NiMo as an overlay layer on low alloy steel
The aim of this study is to reach an increased service life for parts using in sour environment by weld overlaying process. In this investigation, two successive layers of ER410NiMo were clad on low alloy steel substrates. To reduce the likelihood of Hydrogen Induced Cracking (HIC) and producing stable hydrogen traps, Post Weld Heat Treatment (PWHT) was conducted. Microstructural analysis, X-ra...
متن کاملPolymer entanglement density and its influence on interfacial friction.
The entanglement density of amorphous glassy polymers is well known to control their fracture mechanisms under tensile loading. There have been some reports indicating substantial deformation of a glassy polymer's surface region when exposed to interfacial friction. It is shown conclusively here that there is a direct correlation between the entanglement density of a glassy polymer and the defo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2004
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.45.296