Interfacial free energy and stiffness of aluminum during rapid solidification
نویسندگان
چکیده
منابع مشابه
Contraction of Aluminum Alloys during and after Solidification
A technique for measuring the linear contraction during and after solidification of aluminum alloys was improved and used for examination of binary and commercial alloys. The effect of experimental parameters, e.g., the length of the mold and the melt level, on the contraction was studied. The correlation between the compositional dependences of the linear contraction in the solidification rang...
متن کاملRheological behavior of a commercial AA5182 aluminum alloy during solidification
During casting of aluminum alloys, the partially solidified material is submitted to thermally induced strains that can lead to severe casting defects, such as hot tearing. In this work, carried out in the frame of the European project VIR[CAST], the rheological behavior of a partially solidified AA5182 aluminum alloy has been investigated in order to provide constitutive equations to predict h...
متن کاملDSC analysis of Al6061 aluminum alloy powder by rapid solidification Effect of additives
Differential scanning calorimetry (DSC) is a powerful technique that measures the heat evolution from a sample under a controlled condition and studies the phase transformation, precipitation, and dissolution activities. In this work, we investigated the influence of admixed silicon and silicon carbide and the effect of different atmospheres on the heat flow properties and microstructure of ato...
متن کاملStructural Properties of Liquid SiC during Rapid Solidification
The rapid solidification of liquid silicon carbide (SiC) is studied by molecular dynamic simulation using the Tersoff potential. The structural properties of liquid and amorphous SiC are analyzed by the radial distribution function, angular distribution function, coordination number, and visualization technology. Results show that both heteronuclear and homonuclear bonds exist and no atomic seg...
متن کاملINFLUENCE OF THE PRIMARY SOLIDIFICATION ON THE SECONDARY SOLIDIFICATION DURING SEMISOLID METAL (SSM) PROCESSING OF A356.0 ALUMINUM ALLOY BY MECHANICAL STIRRING
Abstract: The aims of this research were to investigate the effects of semisolid metal (SSM) processing parameters (i.e., shear rates –times – temperatures combinations) on the primary solidification products and isothermal holding duration, subsequent to cessation of stirring on the secondary solidification of Al-Si (A356) alloy. The dendrite fragmentation was found to be the governing m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2017
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2017.02.033