Interfacial Bonding and Mechanical Properties of Al/Mg Dissimilar Refill Friction Stir Spot Welds Using a Grooved Tool
نویسندگان
چکیده
منابع مشابه
Microstructure and mechanical properties of friction spot welds of dissimilar AA 5754
In the present study, friction spot welding or refill friction stir spot welding was performed to consolidate dissimilar AA5754 Al and AZ31 Mg alloys. The intermetallic compounds of Al12Mg17 and Al3Mg2 were primarily found in the weld, distributed at the interface between the base materials and in the Al top sheet. The distribution of the intermetallic compounds and the interfacial area between...
متن کاملEffect of tool position on microstructural and mechanical properties of friction stir butt welded joint of AA2024–AA7075 dissimilar alloys
In this research, butt joining of Al2024 and Al7075 plates were performed by Friction Stir Welding (FSW) and the effect of tool position on microstructural and mechanical properties in about 1 mm from center line of joint towards the advancing side (AS) and the retreating side (RS) was investigated at three positions of +1, 0, -1 mm. In this regard, the plates of Al2024 and Al7075 were selected...
متن کاملUltrasonic evaluation of friction stir welds and dissimilar intermixing using synthetic aperture focusing technique
Friction stir welding (FSW) is a recently developed solid-state joining process that uses a specially shaped rotating tool to produce lap or butt joints. At the National Research Council, an inter-institute collaboration was started in 2007 with the goal of exploiting the NDE expertise and applying it for the characterization of friction stir welds for various industrial applications. In partic...
متن کاملEvaluation of microstructure and mechanical properties of friction stir welded copper / 316L stainless steel dissimilar metals
In the present research, friction stir welding (FSW) process was used for butt joining of pure copper plate to 316L stainless steel plate. Mechanical properties and microstructural characteristics of the joint were evaluated by microhardness and tensile tests as well as optical and scanning electron microscope (SEM). It was found that microstructure of the weld nugget (WN) has fine grains where...
متن کاملMechanical Properties of Dissimilar Welds between AISI 4130 and GOST09ch16N4B
Mechanical properties of dissimilar weld joints between GOST09ch16N4B (a martensitic stainless steel) and AISI 4130 thin sheets made by gas tungsten arc welding (GTAW) were studied using ER410NiMo and ER100S-G filler metals in post weld heat treated conditions. Heat treatment cycles consisted of austenitization at 900, 950 and 1000 °C for 1 h and this was followed by oil cooling and tempering a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Crystals
سال: 2021
ISSN: 2073-4352
DOI: 10.3390/cryst11040429