Interfaces and their control in metal matrix composites.
نویسندگان
چکیده
منابع مشابه
Tribocorrosion in Metal Matrix Composites
One of the biggest motivations behind the development of the metal matrix composites (MMCs) is the improvement of the mechanical wear resistance of the unreinforced metallic matrix material mainly by the load-bearing effect of the hard reinforcement phases. However, in a large number of applications, MMCs are also required to operate in intimate contact with aqueous environments, which may lead...
متن کاملBasics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملInterfaces in AlCu-Al2O3 Metal Matrix Composites Studied by Mechanical Spectroscopy
Mechanical spectroscopy has been used for studying the relaxation of the mechanical and thermal stresses, which are built at the fibre-matrix interfaces in AICu-A1203 Metal Matrix Composites (MMCs). The interface strength has been evaluated by the stress dependent damping which exhibits a peak of solid friction. This peak is interpreted as due to interface microcracking. Relaxation of thermal s...
متن کاملCharacterization of Interfaces in Metal Matrix Composites Using the Slice Compression Test
We conduct a finite element analysis of the slice compression test [13] applied to metal-matrix composites. This test, designed to characterize interfaces in composite materials, involves pressing a composite material specimen on a soft plate so that fibers are forced to protrude and intrude into the soft plate leaving a permanent deformation. We focus on the Ti-6Al-4V matrix with SCS-6 silicon...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Hyomen Kagaku
سال: 1985
ISSN: 0388-5321,1881-4743
DOI: 10.1380/jsssj.6.363