InterdigitalH-mode drift-tube linac design with alternative phase focusing for muon linac
نویسندگان
چکیده
منابع مشابه
Muon Phase Rotation Using an Induction Linac*
The proposed neutrino factory requires that the muons produced by the decay of pions and kaons produced by a target be phase-rotated before they can be cooled and then accelerated. This report describes a muon phaserotation system that employs an induction acceleration system. The phase-rotation system consists of a 100meter long induction accelerator, a mini-cooling system with magnetic flux r...
متن کامل2GeV SUPERCONDUCTING MUON LINAC
A muon collider as well as a neutrino factory requires a large number of muons with a kinetic energy of 50GeV or more. Muon survival demands a high gradient linac. The large transverse and longitudinal emittance of the muon beam coming from a muon cooling system implies the need for a large acceptance, acceleration system. These two requirements point clearly to a linac based on superconducting...
متن کاملLongitudinal Emittance Oscillation in a Superconducting Drift Tube Linac
In drift tube linacs a beam energy spread results from the finite beam size. Radial variation of the axial accelerating field induces a beam energy spread, which, in general, will accumulate as the beam passes through successive drift tubes. This paper shows that under some conditions of periodic transverse focusing and longitudinal phase focusing, the correlation between the longitudinal and t...
متن کاملIntegration of Interfaces and Stabilization System in the Design of a Drift Tube Linac
Making an accurate Radio Frequency, RF, design of any accelerating structure is fundamental to ensure that electromagnetic and beam dynamics requirements will be achieved. This is essential for the most complicated accelerating structures like the Drift Tube Linac, DTL; in this case a meticulous design facilitates the RF commissioning too. In this paper the influence of the interfaces and of th...
متن کاملMuon Acceleration in a Superconducting Proton Linac
This note describes how a future Fermilab proton driver [1] based on TESLA superconducting linac modules can perform as both the source of protons to produce the muons and as the accelerator of the muons to be used for a neutrino factory or muon collider. Recent advances in muon cooling [2] have the promise of muon emittances that are compatible with the 1300 MHz accelerating structures that ar...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Accelerators and Beams
سال: 2016
ISSN: 2469-9888
DOI: 10.1103/physrevaccelbeams.19.040101