Integrated reflection and refraction processing of an ultra-shallow seismic survey
نویسندگان
چکیده
منابع مشابه
Shallow Seismic Reflection Survey at Wickiup Dam in Central Oregon
Concerns about potential liquefaction and resulting flowslide type failures at Wickiup Dam in Central Oregon prompted geophysical studies of the left wing dike, studies which included a high resolution seismic reflection survey. High resolution seismic reflection data effectively delineated structures and correlated lithologies to shallow borehole data above the surface of the dipping, basalt b...
متن کاملPitfalls in Shallow Seismic Reflection
Substantial progress has occurred during the past 15 years in development of shallow CDP seismic-reflection techniques, but there are occasional interpretation problems with the resulting data. We discuss examples of the pitfalls of the method, along with some procedures to help avoid them. Problems that often occur include spatial aliasing of ground roll, interpreting processed ground-coupled ...
متن کاملSpecial Issue Shallow seismic reflection section—Introduction
For those interested in shallow seismic reflection (SSR) techniques, this special issue of G E O P H Y S I C S is likely to serve as a useful reference for years to come. The idea for this issue grew out of discussions that took place at the Shallow Seismic Reflection Workshop at the Lawrence Berkeley Laboratory, California, in September 1996. The content of those discussions is the subject of ...
متن کاملShallow seismic reflection does not always work
Shallow seismic reflection has seen widespread use in a variety of environmental, groundwater, and engineering applications over the last 15 years. Seismic reflection, like any other geophysical technique, has reasonably well defined limitations. Besides the well-published resolution limitation, the effectiveness of the technique is strongly dependent, and in many cases controlled, by near-surf...
متن کاملAn integrated inversion of seismic refraction and reflection data using combined wave-equation tomography and full waveform inversion
We have developed an integrated method to obtain highresolution subsurface elastic parameters using combined wave equation tomography (WET) and full waveform inversion (FWI). Both refraction and reflection data are used. During parameterization, long wavelength and short wavelength structures are separated and mapped into velocity and density to account for kinematics and dynamics, respectively...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ASEG Extended Abstracts
سال: 2015
ISSN: 2202-0586
DOI: 10.1071/aseg2015ab032