Instantaneous mechanical fastening of quasi-isotropic CFRP laminates by a self-piercing rivet

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Mechanical properties of vacuum infused CFRP-laminates - dependency of fibres, resins and processing parameters

Carbon fibre reinforced plastic (CFRP) laminates are getting more widely used outside the aerospace industry. For large structures the selected process is often vacuum infusion, due to tool cost and heating/pressure limitations for large components. It has also been shown that such process can give sufficient mechanical properties. In the current EUROPE 103-014 project, supported by the Western...

متن کامل

numerical analysis of rc beams flexurally strengthened by cfrp laminates

this paper presents the results of analytical studies concerning the flexuralstrengthening of reinforced concrete beams by external bonding of high-strength lightweightcarbon fiber reinforced plastic (cfrp) plates to tension face of the beam. three groups of beamswere tested analytically and compared with existing experimental results. results of the numericalanalyses showed that, although addi...

متن کامل

Impact Damage Detection of Toughened CFRP Laminates with Time Domain

Laminated Carbon Fiber Reinforced Polymer (CFRP) composites are very effective in weight saving in aeronautical structural components. For these laminated CFRP structures, it is, however, difficult to detect damage such as delamination, matrix cracks, and local fiber breakages caused by low velocity impact loading In the previous study in 2009, Time Domain Reflectometry (TDR) method was applied...

متن کامل

Strength and Modulus Degradation of CFRP Laminates from Fiber Misalignment

Fiber reinforced polymer (FRP) laminates are being used as external reinforcement for strengthening concrete members. The performance of unidirectional FRP laminates is highly dependent on fiber orientation with respect to applied load direction. In the case of fabrication by manual lay-up, it is possible to have fiber plies installed with improper orientation. In this project, the degradation ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Composite Structures

سال: 2012

ISSN: 0263-8223

DOI: 10.1016/j.compstruct.2012.04.027