Instable Material Flow in Extrusion and Upsetting
نویسندگان
چکیده
منابع مشابه
Extrusion of Ecc-material
An extrusion process especially designed for extrusion of pipes made from fiber reinforced cementitious materials has been developed at Department of Structural Engineering and Materials at the Technical University of Denmark. Engineered Cementitious Composite (ECC) materials have been developed in recent years at Department of Civil and Envirionmental Engineering, University of Michigan. These...
متن کاملMaterial Flow in Rotary Drums
The experimental investigation of material flow in rotary drums is studied. An equipment in the size of pilot-scale was used to collect experimental data for investigation of validity of the conventional steady-state model of material flow in rotary drums. Also, the transient data of the time required for material movement in the empty drum up to any specified cross section are also reported. T...
متن کاملCoupled analysis of material flow and die deflection in direct aluminum extrusion
The design of extrusion dies depends on the experience of the designer. After the die has been manufactured, it is tested during an extrusion trial and machined several times until it works properly. The die is designed by a trial and error method which is an expensive process in terms of time and the amount of scrap. In order to decrease the time and the amount of scrap, research is going on t...
متن کاملHOMOTOPY PERTURBATION METHOD FOR SOLVING FLOW IN THE EXTRUSION PROCESSES
In this paper, the homotopy perturbation method (HPM) is considered for finding approximate solutions of two-dimensional viscous flow. This technique provides a sequence of functions which converges to the exact solution of the problem. The HPM does not need a small parameters in the equations, but; the perturbation method depends on small parameter assumption and the obtained results. In most ...
متن کاملInvestigation of instable fluid velocity in pipes with internal nanofluid flow based on Navier-Stokes equations
In this article, the instable fluid velocity in the pipes with internal nanofluid is studied. The fluid is mixed by SiO2, AL2O3, CuO and TiO2 nanoparticles in which the equivalent characteristic of nanofluid is calculated by rule of mixture. The force induced by the nanofluid is assumed in radial direction and is obtained by Navier-Stokes equation considering viscosity of nanofluid. The displac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: CIRP Annals
سال: 1982
ISSN: 0007-8506
DOI: 10.1016/s0007-8506(07)63295-8