Instabilities of High Speed Dislocations
نویسندگان
چکیده
منابع مشابه
Dislocations and morphological instabilities: Continuum modeling of misfitting heteroepitaxial films
Mikko Haataja,1,* Judith Müller, A. D. Rutenberg, and Martin Grant Centre for the Physics of Materials, Department of Physics, McGill University, Rutherford Building, 3600 rue University, Montréal, Québec H3A 2T8, Canada Instituut-Lorentz for Theoretical Physics, University of Leiden, P.O. Box 9506, NL-2300 RA, Leiden, The Netherlands Department of Physics, Dalhousie University, Halifax, Nova S...
متن کاملExperimental Study of a High Speed Micro Waterwheel
Waterwheels are the oldest types of hydraulic machines. These turbines are of relatively simple design, large diameter, low rotational speed and high torques. But applying them as micro hydros of high speed and small diameter is yet to be explored. A micro hydro waterwheel of one meter diameter was designed and manufactured at the Iranian esearc†h Organization for Science and Technology (IROST...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملHigh-Speed Penternary Inverter Gate Using GNRFET
This paper introduces a new design of penternary inverter gate based on graphene nanoribbon field effect transistor (GNRFET). The penternary logic is one of Multiple-valued logic (MVL) circuits which are the best substitute for binary logic because of its low power-delay product (PDP) resulting from reduced complexity of interconnects and chip area. GNRFET is preferred over Si-MOSFET for circui...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Letters
سال: 2018
ISSN: 0031-9007,1079-7114
DOI: 10.1103/physrevlett.121.145502