Input Balun Design Method for CMOS Differential LNA
نویسندگان
چکیده
منابع مشابه
A 0.13-µm CMOS 0.1-12GHz active balun-LNA for multi-standard applications
A 0.1–12GHz Low Noise Amplifier (LNA) with an active balun is proposed for multi-standard applications. In order to realize wideband matching and single-to-differential (S2D) conversion simultaneously, a single-end resistive negative feedback amplifier is adopted as the first stage for input impedance matching, and a novel active balun consisting of common source amplifier and source follower i...
متن کاملA Linearity-Improved Ultra-Wideband Balun-LNA for Cognitive Radio
An ultra-wideband low noise amplifier for cognitive radio applications covering 50 MHz to 10 GHz is designed in a 65-nm CMOS technology. A three-stage dc-coupled common source amplifier with RC degeneration at the last stage optimizes the gain, linearity and output gain-phase balancing. Throughout the covered band, the simulated voltage gain is >23.3 dB whereas the noise figure is <3.4 dB. The ...
متن کاملDesign technique of broadband CMOS LNA for DC - 11GHz SDR
This paper presents a DC–11GHz CMOS low noise amplifier (LNA) for software-defined radio (SDR). The broadband performance is extended to cover the spectrum from near DC to 11GHz by adopting extra inductors with modified resistive feedback, folded current reuse topology. Bandwidth extension is proposed by inserting pole splitting, interstage and LC ladder inductors. A source follower jointly act...
متن کاملCMOS LNA for BLE Applications
Bluetooth Low Energy (BLE) is an advanced technology that has been designed as complementary technology to classic Bluetooth and also it is the lowest possible power wireless technology that can be designed and built. This paper provides an overview of bluetooth low energy technology and utilization of CMOS Low Noise Amplifier (LNA) for BLE applications. The aim of this paper is review and comp...
متن کاملDesign of 1.8V 1GHz 0.18 m CMOS LNA for GPS
the low noise amplifier is the key part for front-end device of the receiver in the GPS. A 1.8V 0.18um CMOS LNA for GPS applications has been designed. Two kinds of low noise amplifier (LNA) for single-end cascade structure and differential cascade structure respectively are presented in this paper. Cadence software is used to optimize the two circuits. It provides a series of good results in N...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2017
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2017.28.5.366