Inlet and Outlet Flow of a Mixed-Flow Pump.

Numerical Simulation of Cavitation in Mixed Flow Pump

The purpose of this study is to investigate the performance and three-dimensional behavior of the flow in a mixed flow pump and the way cavitation phenomenon is affected by different parameters such as fluid temperature, pump speed and flow rate. Computational fluid dynamic software FLUENT 6.3 was utilized to simulate the whole flow field of the pump. RNG k-ε model combined with standard wall f...

Investigating the effect of Inlet and Outlet location on Flow field and Sedimentation pattern of a rectangular settling basin using CCHE2D

Water obtained from any source may contain impurities induced by erosion, dissolved minerals, dissolved gases and material produced from organic matter decomposing. If the amount of these substances exceed a certain limit, not only the water would not be potable, but the water containing the material will not be suitable to be used in most applications, or at least before treatment cannot be ap...

Effect of Inlet and Outlet Flow Conditions on Natural Gas Parameters in Supersonic Separation Process

A supersonic separator has been introduced to remove water vapour from natural gas. The mechanisms of the upstream and downstream influences are not well understood for various flow conditions from the wellhead and the back pipelines. We used a computational model to investigate the effect of the inlet and outlet flow conditions on the supersonic separation process. We found that the shock wave...

Energy Performance and Flow Patterns of a Mixed- Flow Pump with Different Tip Clearance Sizes

Tip clearance between blade end and shroud is inevitable in pump operation and of great importance on pump energy performance and pressure fluctuation. As the tip clearance size increases, the head and efficiency of the mixed flow pump drop accordingly. The simulation results show that the development of a leakage vortex is observed as the tip clearance increases, and the trajectory of this lea...

Rarefied gas flow in microtubes at different inlet-outlet pressure ratios