Inlet Air Fogging of Marine Gas Turbine in Power Output Loss Compensation
نویسندگان
چکیده
منابع مشابه
Discussion of Some Myths/features Associated with Gas Turbine Inlet Fogging and Wet Compression
Gas turbine inlet fogging and overspray (high-fogging) have been considered the most cost-effective means of boosting a gas turbine’s total power output, especially under hot or dry weather conditions. The result of employing fogging or overspray is indisputably clear − total power output is increased; however, development of the theory and explanation of the phenomena associated with fogging a...
متن کاملParametric Analysis of Cooled Gas Turbine Cycle with Evaporative Inlet Air Cooling
The article investigates the effect of compressor pressure ratio, turbine inlet temperature and ambient temperature on the performance parameters of an air-cooled gas turbine cycle with evaporative cooling of inlet air. Air f ilm cooling has been adopted as the cooling technique for gas turbine blades. The mass of coolant required for turbine blade cooling is calculated f or a selected range of...
متن کاملPerformance Evaluation Of Gas Turbine By Reducing The Inlet Air Temperature
Performance of a gas turbine is mainly depends on the inlet air temperature. The power output of a gas turbine depends on the mass flow rate of air. Now days the atmosphere temperature is hot, so the air is less density, the mass flow rate will reduce and automatically the power output will reduce. A reduce of 1°C temperature of inlet air increases the power output by approximately 0.7MW. To re...
متن کاملIntegration of steam injection and inlet air cooling for a gas turbine generation system
The temperature of exhaust gases from simple cycle gas turbine generation sets (GENSETs) is usually very high (around 500 C), and a heat recovery steam generator (HRSG) is often used to recover the energy from the exhaust gases and generate steam. The generated steams can be either used for many useful processes (heating, drying, separation etc.) or used back in the power generation system for ...
متن کاملStage Marine Gas Turbine Blade
Turbine blades of a gas turbine are responsible for extracting energy from the high temperature, high pressure gases. These blades are operated at elevated temperatures in aggressive environments and are subjected to large centrifugal forces. As many as 42 percent of the failures in gas turbine engines were only due to blading problems and the failures in these turbine blades can have dramatic ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polish Maritime Research
سال: 2015
ISSN: 2083-7429
DOI: 10.1515/pomr-2015-0071