Injection Molding Processing-Flow Behaivour of Multi-Phase Polymer Systems for Injection Molding and Low Presure/Low Strain Molding Process "SP Molding".
نویسندگان
چکیده
منابع مشابه
Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملImage Analysis Dedicated to Polymer Injection Molding
This work follows the general framework of polymer injection moulding simulation whose objectives are the mastering of the injection moulding process. The models of numerical simulation make it possible to predict the propagation of the molten polymer during the filling phase from the positioning of one point of injection or more. The objective of this paper is to propose a particular way to op...
متن کاملFinding efficient frontier of process parameters for plastic injection molding
Product quality for plastic injection molding process is highly related with the settings for its process parameters. Additionally, the product quality is not simply based on a single quality index, but multiple interrelated quality indices. To find the settings for the process parameters such that the multiple quality indices can be simultaneously optimized is becoming a research issue and ...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Kobunshi
سال: 1993
ISSN: 0454-1138,2185-9825
DOI: 10.1295/kobunshi.42.740