Injection Molding of Mixture of Water-Holding Alumina and Water
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Water addition, evaporation and water holding capacity of poultry litter.
Litter moisture content has been related to ammonia, dust and odour emissions as well as bird health and welfare. Improved understanding of the water holding properties of poultry litter as well as water additions to litter and evaporation from litter will contribute to improved litter moisture management during the meat chicken grow-out. The purpose of this paper is to demonstrate how manageme...
متن کاملOn the Study of Mechanical Properties of Aluminum/Nano-Alumina Composites Produced via Powder Injection Molding
Powder Injection Molding (PIM) is a precision manufacturing process used for production of advanced composites. Mixing of polymeric binder with metal powders, molding of feedstock, de-binding of brown parts and sintering of green samples are four main steps of this process. In the present study, the compounds containing multi-component binder system and aluminum/ nano-alumina (0-9 wt.%) powders...
متن کاملInvestigation of effective parameters on fabrication of alumina parts by low pressure injection molding (LPIM) method
Low pressure injection molding (LPIM) method in this paper is investigated as a method of forming alumina parts. This is one of the methods of making engineering ceramics with complex shapes and high dimensional accuracy. In this method, a binder system (paraffin wax + carnuba wax) was used as a plastic agent for easy formation of alumina particles. Different parameters such as feedstock temper...
متن کاملMultifluid Flows, Interface Capturing and Application to the Simulation of the Water Assisted Injection Molding Process
In this paper, we present a 3D finite element approach to compute multifluid flows. Special attention is given to capture the water/polymer interface, that can be obtained used a VOF (Volume of Fluid) or a Level Set technique, with or without adaptative meshing. Results are shown, in for 2D and 3D parts.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 1989
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.97.656