منابع مشابه
Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملFormability of Magnesium Alloys
The paper is focused on issues of processing of non-ferrous metals in practice, namely on Mg-Al-Zn based on magnesium alloys with graded Al contents. It is well known that forming of these alloys is difficult since this feature is caused by their crystallographic arrangement. Nevertheless, application of appropriate methods of forming, such as e.g. some of SPD processes, makes it possible to ac...
متن کاملMicrostructure and Mechanical Properties of Inconel 625 and 7 18 Alloys Processed by Powder Injection Molding
Powder injection molding of superalloys offer a potential route for the manufacture of small and geometrically complex components for the aircraft engine industry. In this investigation, 625 and 718 alloy powders with an average size below 10 pm were injection molded into tensile test bars which were then sintered in a hydrogen atmosphere at diverse temperatures after debinding. Other 718 alloy...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2013
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.63.165