Injection molding of Fe-6.5%Si alloys. (Part 1).
نویسندگان
چکیده
منابع مشابه
Characterization of an Injection Molding Process for Improved Part Quality
An injection molding process was characterized with respect to certain physical characteristics of an injection molded part. The produced part, the “Triconnector”, is a planar Lego-like piece, which was shot from ABS thermoplastic on a Morgan-Press G-100T Injection Molding Machine. Using statistical design of experiments, we identified the most significant parameters affecting part quality. The...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملMicrostructure and Mechanical Properties of Inconel 625 and 7 18 Alloys Processed by Powder Injection Molding
Powder injection molding of superalloys offer a potential route for the manufacture of small and geometrically complex components for the aircraft engine industry. In this investigation, 625 and 718 alloy powders with an average size below 10 pm were injection molded into tensile test bars which were then sintered in a hydrogen atmosphere at diverse temperatures after debinding. Other 718 alloy...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1989
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.36.188