Inhibited aluminization of an ODS FeCr alloy
نویسندگان
چکیده
منابع مشابه
Improved ODS Alloy for Heat Exchanger Tubing
The Department of Energy (DOE), National Energy Technology Center (NETL), has initiated a strategic plan for the development of advanced technologies needed to design and build fossil fuel plants with very high efficiency and environmental performance. These plants, referred to as “Vision 21” by DOE, will produce electricity, chemicals, fuels, or a combination of these products, and possibly se...
متن کاملMaterials and Components Development for Advanced Turbine Systems - Ods Alloy Development
Oxide dispersion strengthened (ODS) alloys have been under intensive development over the past four decades due to their excellent high-temperature creep strength and good oxidation resistance. Nickel-based ODS alloys are the combination of gamma prime (γ’) strengthened superalloy with yttrium oxide evenly distributed throughout the matrix to allow the strength to be maintained to much higher t...
متن کاملVibrational entropy of spinodal decomposition in FeCr
Inelastic neutron-scattering spectra were measured on stoichiometric Fe0.50Cr0.50 prepared as a bodycentered-cubic bcc solid solution, and after increasing amounts of chemical unmixing on the bcc lattice induced by annealing the solid solution at 773 K. These spectra were reduced by a conventional procedure to a neutron-weighted vibrational density of states. Mössbauer spectrometry was used to ...
متن کامل156-2007: Tabbing through ODS
The author presents a significant approach to aligning multiple variables inside a cell by applying tabs to the ODS reporting process. Consequently what appeared to be one limitation in classical ODS reporting has been overcome. The technique makes it easy to adopt mixed patterns in presenting the result of proc report, which have become necessary under certain circumstances such as patient pro...
متن کاملAN INVESTIGATION ON ABRASIVE WEAR BEHAVIOUR OF Fe-C-Mo-FeCr COMPOSITE PRODUCED BY POWDER METALLURGY
In this study, the effect of chromium carbide (Cr7C3) on abrasive wear behavior of Fe-C-Mo-FeCr composite was investigated. Composite, which was produced by a powder metallurgy route was containing 3 wt.% Mo, 1.5 wt. % C and 4,8,12 wt. % FeCr with the different particle sizes. In the experiments, wear resistance of samples were determined using different loads by a pin on disc wear tester. Micr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2012
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2012.05.041